![]() ![]() Assuming an 8.5mm wall if we cut it to 6.0mm we'd fit in 43mm (64cc) piston. I bet we could cut it down to roughly 2/3 of it's original thickness? Your thoughts?Įdit: The sleeve is about 8-9mm thick. I'll try and post some info on the thickness of the sleeve tomorrow. The Wiseco pistons might work but I'm concerned I'd get it bored and plated for the 41mm piston and then abe would announce a 43mm 4-valve piston and you guys would all be faster than me or I'd pay another 500$. ![]() My guess is that it would work but it'd only be 58.5cc which would be a shame if there's like a 65cc piston option that's workable. The only issues that seem likely to pose a problem is the valve cutouts (I can't find a pic) and the compression ratio but I think the compression ratio would be pretty close. The wrist pin is likely the same too cuz they're both Honda's. I don't think height would be an issue as an XR50 is also 38mm bore and 44mm stroke just like our ruckus's. There's info on the XR50 stuff in the post above yours. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |